kingsea 5pcs Metal Steel 48P Pinion Gear 3.175mm Shaft 22T 23T 24T 25T 26T Pitch Gears with Screwdriver 1/10 RC Brushless Brush Motor RC Upgrade Part
*【Compatible with】(3.175mm) Shaft Size Motors,make sure your RC motor shaft have the same diameter.
*【Spec】48 Pitch, 22T 23T 24T 25T 26T
*【Material】Made Of Quality Hardened Steel to increased wear resistance and improve fatigue life,make them roll smoothly.
*【Suit for】RC 1/16 E-Revo Slash VXL,1/10 Rustler VXL,Stampede VXL,Slash VXL 2WD Ford F-150 Raptor Ford Mustang GT.Associated Losi Redcat ECX Arrma 1/10 Rc Car etc.
*【Package】48p 22T 23T 24T 25T 26T pinion gear and a hardened hex key, Variety of tooth pinions allows for more gear setups
This is hardened steel 22T 23T 24T 25T 26T tooth, 48 pitch pinion gear Suitable for 1/10 RC Car motors with 3.175mm shaft
Feature
Hardened steel to increased wear resistance and improve fatigue life
Nitrided to enhanced hardness corrosion resistance
Tooth count: 22T 23T 24T 25T 26T
Tooth pitch: 48 pitch
length: 9mm
For shaft: 3.175mm
Package include:
1 X 48p 22T pinion gear
1 X 48p 23T pinion gear
1 X 48p 24T pinion gear
1 X 48p 25T pinion gear
1 X 48p 26T pinion gear
5 X Screws
1 X Hex Key
Make sure you thread lock the grub screw. They are hard to find when they fall out.
Larger gears will result in higher speeds while smaller gears provide more torque.
For quicker acceleration go for a smaller pinion gear (with fewer teeth) and larger spur gear (with more teeth).
Your car will accelerate off the mark very quickly with more torque, and you'll also benefit from cooler running temperatures, extending the life of your motor and ESC.
How to install the pinion gear:
You will probably need to loosen the motor a bit, in order to fit the pinion gear on. Make sure you lock it in place on the flat portion of the motor shaft.
When you are tightening it back up, make sure you leave about a gap between the pinion gear and the spur gear. That gap will be very small. It should be about the thickness of a piece of paper.
