A A IN AA039W 300 PSI Heavy Duty Air Hose Reel With 50FT Auto Rewind Premium Retractable air hose, Air Hose Reel Wall Mount 3/8'' Flexible Hybrid Hose
*【Include】All steel air hose reel,3/8 In.x 50 Ft hybrid air hose,adjustable plastic hose stopper and mounting bolts
*【Auto-connection】 It adopts automatic water connection design,quick,convenient and saves time and effort.
*【Smooth operation】The full flow solid swivel joint ensures smooth and flexible, uninterrupted fluid flowing. The multi-position release ratchet spring is fully enclosed.
*【Hose】The hybrid and retractable air hose with maximum air pressure: 300 PSI; Air inlet (female):3/8NPT， , air outlet (male): 3/8 NPT,13.65 inch long, 5.1 inch wide and 14.25 inch high
*【Temperature】 It suitable for the range from -20℃ to 60℃ .
Use
1. Check wheel operation by slowly pulling the hose out. You should hear a clicking noise.
2. To lock the hose, pull it out a minimum of 1/2 revolution and it will stay locked after the first, second, or third click.
3. To unlock, slowly pull until the clicking stops, and let it retract until the hose slipper hits the hose guide.
4. Attach a coupler (not included) to your air compressor hose and apply Teflon tape to the outlet fitting on the reel. Connect the coupler (not included) to the outlet fitting.
5. Attach a coupler (not included) onto the end of the hose, and connect to your air tool.
Replacement of Hose
1. Pull out the old hose and securely lock Hose Reel.
2. Disassemble the Rubber Bumper Block by the Bolt and the Nuts
3. Disconnect the old hose from the swivel joint and remove the hose.
4. Run the Hose through the Rubber Bumper Block, and through the drum flange.
5. Use Teflon tape on the hose fitting threads and screw the fitting onto the swivel and tighten, Re-assemble the Rubber Bumper Block with the Bolts and the Nuts .
6. Attach hose stopper on the end of the hose near the outlet fitting
7.Carefully release drum latch and allow the Hose to wind onto the reel. Try to evenly distribute the Hose across the reel.
Installation of Reel
1. Make a paper template modeled after the one above.
2 The Reel may be installed on the wall, floor, or ceiling (at least ten feet above the floor).
3. Remove the bolts that attach the guide roller bracket to the support post to re-position the bracket for the appropriate location. Replace bolts and tighten.
4. Drill holes [o accommodate 1/2 inch bolts (not included). Make sure you are drilling into a solid backing, or use the appropriate hardware to anchor in the bolts.
5. Mount reel and secure the four bolts (not included) through the 1/2" holes in the bracket.
