Table Inserts (Pack of 2) for 14'' Band saws or Scroll saws（Diameter: 2.5 in, Thickness: 0.1 in）
Availability: Pre-Order, Inquiry Price
*Please measure your saw as some Delta & Rockwell &Grizzly14" bandsaws has slightly smaller holes for the throat plate. If so some slight filing or sanding may be required.If you mind, please dont buy it.
*Make sure your insert recess has the locating pin on the side, not on the rear.
*use on 14" Band Saws and 24" Scroll Saws.2&1/2" X .100 thick Please measure your saws recess to ensure proper fit
*They fit Delta, Rockwell, some Jet, Ridgid, Grizzly, and other imports.
*IMPORTANT INSTALLATION NOTE:I have sold several hundred of these and occasionally someone will have the problem of it being a bit too large. First make sure the lip of the hole is free from dirt. If a table alignment pin,is not tight or missing,often the blade mounting slot will close up some over time which reduces the insert hole diameter slightly. I tap a flat head screw driver into the blade installation slot a bit to wedge it open. That should spread the insert hole enough for it to fit
Table Inserts (pack of 2).
Material: Aluminum
Make sure your insert recess has the locating pin on the side, not on the rear.
use on 14" Band Saws and 24" Scroll Saws.2&1/2" X .100 thick Please measure your saws recess to ensure proper fit. They fit Delta, Rockwell, some Jet, Ridgid, Grizzly, and other imports.
Three inserts to protect your expensive blades
Please measure your saw as some Delta & Rockwell &Grizzly14" bandsaws has slightly smaller holes for the throat plate. If so some slight filing or sanding may be required.If you mind, please don't buy it.
IMPORTANT INSTALLATION NOTE:I have sold several hundred of these and occasionally someone will have the problem of it being a bit too large. First make sure the lip of the hole is free from dirt. If a table alignment pin,is not tight or missing,often the blade mounting slot will close up some over time which reduces the insert hole diameter slightly. I tap a flat head screw driver into the blade installation slot a bit to wedge it open. That should spread the insert hole enough for it to fit
